|
Post by biofossil on Jan 31, 2022 18:50:34 GMT
I have a problem with the panel screws behind the machines rusting. I replaced every screw about 6 months ago and they have rusted again. Is there a special type of screw that needs to be used? I order most things from grainger. The last screws I used advertised as "stainless steel" screws. It was a lot of work to replace them all. Then here it is 6 months down the line I'm right back where I started. Thanks for your help..
|
|
|
Post by gnurk on Jan 31, 2022 21:15:31 GMT
the stainless you got was probably really thin see if you can get some 316 stainless if they are for the fmc machines order them from fmc
|
|
|
Post by Chuck Weddle on Jan 31, 2022 22:32:45 GMT
Bleach corrodes stainless steel.
|
|
|
Post by biofossil on Feb 1, 2022 12:24:12 GMT
Sorry.. I should have been more clear. It's the wooden chase panels behind the machines. Sorry about that.
|
|
|
Post by Chuck Weddle on Feb 1, 2022 13:32:14 GMT
Can you coat them with a thin layer of clear silicone?
|
|
|
Post by qman213 on Feb 1, 2022 21:50:32 GMT
I don't know if this would work in your case but they make little plastic caps that cover the screw heads. I think Grainger and McMaster Carr both have them.
|
|