Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Jun 10, 2022 18:16:14 GMT
Guys i need help, i have a portable RO that the wires inside the electronic was burnt, replaced them including the switches, power, valve and disinfection. now when i turn on the valve no water on the drain. i followed the lines and keep checking for water and i do, just little to no water on the waste..replaced membrane, replaced pump head, my pump pressure is only 5 psi. Help! Attachments:
|
|
joey
Full Member
Posts: 226
|
Post by joey on Jun 10, 2022 18:32:33 GMT
What about the inlet water valve? I believe there is a valve that closes if there is no water pressure....If it's not the same valve you can check that too.
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Jun 10, 2022 19:19:12 GMT
Thank you for your response, I did replace the valve and check it if water goes through
|
|