Post by Adnan on Oct 30, 2022 7:26:22 GMT
Hi, guys I have a machine with a 9.12 SW version which takes more time than usual during disinfection.
the machine draws the disinfectant and starts to circulate it. the temperature goes to 90 then the heater is cut off. the temperature starts to decrease until reaches 70 then an error message appears ( Temperature too low). after some seconds the heater starts again and the temperature goes up again. this happened 4 times during the short disinfection ends :/ any recommendations?
the machine draws the disinfectant and starts to circulate it. the temperature goes to 90 then the heater is cut off. the temperature starts to decrease until reaches 70 then an error message appears ( Temperature too low). after some seconds the heater starts again and the temperature goes up again. this happened 4 times during the short disinfection ends :/ any recommendations?
