|
Post by mrceniceros on Dec 1, 2022 21:14:14 GMT
T machine with over 15'000 hrs. Just replaced temperature sensor, when calibrating connector 41 (5.117) I get 'Operator Error.' I've used a different test connector, same message. Any ideas why?
Thank you.
|
|
stuff
Full Member
WooooooooooooooooooooooooooooOOOOOOOOOOOOOOOOOOOOOOOOOOOOOooooooooooooooooooooooooOOOOOOOOOOOOOOOOOO
Posts: 226
|
Post by stuff on Dec 2, 2022 13:40:49 GMT
replace the operator with a known working one. lol . you can put the machine into dialysis mode and plug that resistor in. then goto debug screen and see what it is actually reading. could be the "new" part is bad. New just means not used, not that it is working.
|
|
|
Post by gnurk on Dec 2, 2022 16:04:18 GMT
if part is bad call fmc and say you got a out of box failure they will give you a new one and a RGA to send back the bad one
|
|