kyle
New Member
Posts: 39
|
Alarm 14
Apr 12, 2023 7:04:33 GMT
via mobile
Post by kyle on Apr 12, 2023 7:04:33 GMT
What usually causes alarm 14 on aquaboss? I had my aquaboss do the alarm 35 (aqua control- i know this always happens because one of my pre-treatment devices does a backwash) and after 5 mins, it did an alarm 14.
|
|
|
Post by Admin on Apr 12, 2023 11:16:56 GMT
Alarm 14 on your Aquaboss is a pressure alarm - however, if it's a single stage RO - it's conductivity related. When you get this alarm, check your conductivity. I bet it's over 60 uS
|
|
kyle
New Member
Posts: 39
|
Post by kyle on Apr 13, 2023 16:05:36 GMT
I noticed that after my Alarm 35 (Aqua control- which my water softener backwashes that's causing this and it's normal), Alarm 14 pops up after 5 mins. What could've caused this?
|
|
|
Post by Admin on Apr 13, 2023 17:08:48 GMT
It's very hard to tell as A14 is related to pressure, and the conductivity. It's similar to the A16 on the dual stage - pressure and conductivity.
|
|
|
Post by Chuck Weddle on Apr 13, 2023 18:00:19 GMT
I noticed that after my Alarm 35 (Aqua control- which my water softener backwashes that's causing this and it's normal), Alarm 14 pops up after 5 mins. What could've caused this? If it's conductivity related like Admin said and it happens after the softener regenerates. You may have something going on with your softener like I do that's keeping sodium in the softener.
|
|