|
Post by guest on Jun 29, 2021 17:16:55 GMT
What would cause a display screen on a T machine to "glitch" (not sure if that would be a exact description". When you look at the screen for a few seconds it will blink or glitch. It's not very noticeable unless your staring at it for a few seconds. It's very strange. The machine is a 3t0s with 30,000 hours. I am at the point of having to replace several displays through out my machines. So I was curious if it may be time to replace this display. Thanks for any info..
|
|
|
Post by Chuck Weddle on Jun 29, 2021 18:11:57 GMT
I'm no longer familiar with Fresenius machines but it sounds like loose/dirty/oxidized connections. Get a can of electronic contact cleaner. With the machine off and unplugged, disconnect any screen cables and spray both male and female ends then connect/disconnect them a couple times. Wait a few minutes to make sure the cleaner has evaporated then give it a try.
|
|