Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Jul 5, 2021 17:13:06 GMT
I know I have seen the "fix", but forgot...
"Resirc Error in Heat".... what have y'all had success with in a solution. Occasionally I get flow inlet in dialysis. |
|
|
|
Post by dave74 on Jul 5, 2021 20:01:10 GMT
Have you checked your deaeration pressure? Have you inspected the brushes on the deaeration motor? If the motor is intermittently cutting out, it could cause occasional inlet flow errors. If the deaeration pressure isn't up to specs, it could cause a flow recirc error.
|
|
|
|
Post by stewie on Jul 6, 2021 8:19:13 GMT
I just had this issue yesterday and it was the float switch.
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Jul 6, 2021 12:10:24 GMT
The one time I saw this it was the valve under the hydrochamber.
|
|
|
|
Post by Doctor Zoidberg on Jul 7, 2021 23:54:22 GMT
Deair pump or heat exchanger are my first 2 suspects when I see this error. If it's leaking from the vet tube, heat exchanger is most often the culprit.
|
|
|
|
Post by swoalyghost58 on Jul 14, 2021 18:39:02 GMT
If you are getting a flow inlet as well in dialysis then definitely look at deaeration motor, either needing to be rebuilt, or calibrated or both. Also, if you have rebuilt and tried to calibrate and you are maxing out in order to reach desired pressure, then swap out pump head as well.
|
|
|
|
Post by Guest1 on Jul 14, 2021 21:30:17 GMT
Don't forget to check for a pinched vent tube.
|
|
