|
|
Post by CJ on Mar 17, 2022 19:17:42 GMT
So I have a brine tank that will not refill, everything else works fine. It will draw up the brine but when it comes time to refill it just sounds like air going into the brine tank and no water. I have already replaced float assembly and brine valve assembly and rebuilt head. Any suggestions?
|
|
|
|
Post by Chuck Weddle on Mar 19, 2022 10:45:51 GMT
Providing more information may help to get more ideas. Such as control head make/model, brine tank size, softener capacity, etc. I know that at least for me, Fleck heads aren't the easiest things to rebuild. Providing it is done correctly, a couple other things to check would be: - Injector - This creates the venturi to draw the brine, I don't know if this is used during refill but I have seen them have debris in them as well as being disintegrated.
- Drain restrictor - These too I have seen clogged and also the orifice completely disintegrated.
Otherwise, it likely has a crack/hole and you are probably looking at replacing the entire control head.
|
|
