|
Post by kendec65 on Jul 20, 2022 17:47:51 GMT
I have a machine 9.1B a little over a year old that is alarming sound + LED failure after start up. Under remarks, it says LLS: MSG #67. I may have over looked it, but where can I find out what the message means? TIA, Ken
|
|
|
Post by qman213 on Jul 20, 2022 22:13:34 GMT
The problem is most likely either the speaker or the Front Panel Board.
|
|
Adnan
New Member
B Braun
Posts: 41
|
Post by Adnan on Jul 21, 2022 5:28:02 GMT
''sound LED'' is a step of the self-test, so, you should hear an alarm sound and see the LED lighting if not! you have a problem with one of those. Change the speaker if you could not hear a sound
|
|
|
Post by kendec65 on Jul 21, 2022 9:59:59 GMT
I will check that out, and thanks, but my question more or less is, where do I find what MSG #67 means or is trying to tell me?
|
|
|
Post by Chuck Weddle on Jul 21, 2022 10:36:28 GMT
I will check that out, and thanks, but my question more or less is, where do I find what MSG #67 means or is trying to tell me? If you touch the alarm message at the bottom of the screen, the message window will pop up.
|
|
Adnan
New Member
B Braun
Posts: 41
|
Post by Adnan on Jul 21, 2022 10:38:11 GMT
|
|
|
Post by kendec65 on Jul 21, 2022 11:53:17 GMT
Thank you all!
|
|
|
Post by bcjammerx on Aug 6, 2022 17:37:39 GMT
even if you can hear a sound I've had v8's do this and the speaker made a sound but still caused this error. First thing I did was press on every connector, worked fine for a few weeks then did this again with the speaker still alarming (of course it never gave me this error when I tested it). I replaced the speaker and no more alarms
|
|
|
Post by SrCusEngr on Aug 8, 2022 2:56:38 GMT
Alarm messages are contained in a chapter in the IFU, the Operator’s Manual. The second book that no one reads. The first is the service manual. 😂
|
|