|
Post by Asmith on Sept 15, 2022 20:12:52 GMT
I have a T machine with 26,000hrs on it. When the machine turns on the screen light is dim. Touch screen works fine. After a few minutes in rinse the screen is back to normal. I've reset boards and cables. I'm stumped.
|
|
|
Post by herbiehancock on Sept 15, 2022 23:12:17 GMT
i had a machine not long ago that had a dim screen and it was due to a bad UI board. i would try and swap with known good and try. it would be a good place to start......
|
|
|
Post by MikeytheChain on Sept 16, 2022 18:00:27 GMT
Sometime the LCD ribbon cable can push over a pin the UI/Mics connection. The pins are supah-tiny. But, I have been able to get them straightened out with a very thin syringe needle and a magnifier. Not sure if this is the case as the screen gets back to normal after a few minutes. Anyway, this can save you the cost of a new UI/Mics.
|
|