|
|
Post by Guest on Jul 19, 2021 18:02:02 GMT
I have older phoenix machines- the screen is jumping around or you get the pink lines thru it- i have tried the LVDX 18/24 Bit cables and boards- the PC board and used electronic contact cleaner on connections, ribbon cables- any other suggestions- Thanks
|
|
|
|
Post by gfreely on Jul 19, 2021 18:55:11 GMT
You could check J38 or swap the Ctrl board/Inverter on the back of the screen. See if the Ctrl board LED flashes each time you touch the screen. If not then it could be the board. If it does then it could be the screen assy itself.
Does "older" mean that you are using 5V screens? |
|
|
|
Post by Guest on Jul 20, 2021 12:10:41 GMT
they are the 3.3 v screens- the inverter board has 2 top connections from the screen and the other connection to the motherboard
|
|
|
|
Post by Guest on Jul 27, 2021 12:08:47 GMT
I ended up changing the screen at 3grand- could of bought a 80in tv for less than half of that cost
|
|
|
|
Post by gfreely on Jul 27, 2021 13:16:11 GMT
Currently, I have every model screen represented in my clinic (5V, 3.3V NEC, 3.3V Sharp...). Since you can't get the 5V anymore, it's a full retrofit if one goes bad. Hard to justify 1/3 of the cost of a new machine for ONE part....:/
|
|
|
|
Post by Guest on Jul 27, 2021 15:23:38 GMT
isn't that the truth- they are currently looking at hrs and cost to see if new machines are to be purchased- i have 3 more machines that need new screens- plus flow meters are starting to wear
|
|
