|
|
Post by biomedfossil on Nov 7, 2022 17:42:54 GMT
I believe I have seen this before but I can't for the life of me remember what caused the problem.
I have T machines with 40,000 hours and the machine is at a stand still. The dialysis flow is blinking no matter what flow is showing. I was hoping someone could help me out.
Thank You..
|
|
|
|
Post by dave74 on Nov 7, 2022 22:03:23 GMT
I believe that light blinks when the flow has been turned off for over five minutes. Most of the time when I see this, it is because a biomed accidentally pushed the flow off when he was working on a machine or a PCT accidentally pushed it when he was repositioning a machine.
|
|
|
|
Post by GuestCAMonday on Nov 7, 2022 23:11:02 GMT
I believe that light blinks when the flow has been turned off for over five minutes. Most of the time when I see this, it is because a biomed accidentally pushed the flow off when he was working on a machine or a PCT accidentally pushed it when he was repositioning a machine. T machines don't have a dialysate flow button/indicator light, but you are still correct as it pertains to K/K2s. I'm not sure of the cause but for T machines make sure you press the confirm button when selecting the flow rates. I've found that in the flow rate box if you press the enter key, the machine doesn't flow rate selection. |
|
|
|
Post by jaretac on Nov 9, 2022 3:01:17 GMT
Turn flow to off and confirm then change it back to whatever you want
|
|
