|
Post by Taco123 on Mar 9, 2023 13:48:20 GMT
Recently replaced function board and get a Act Pump fail on boot up. Do I need to redo all the calibrations in T & C mode to get the machine to boot up correctly? Unfortunately the Eprom chip on the original board isn't functioning anymore. So the machine can't boot up. I did a software upgrade on the boards and proceeded to get a conductivity fail error.
|
|
stuff
Full Member
1111111111111111111111111111111111111111111111111111111111111111111111111111111111111111111111111111
Posts: 239
|
Post by stuff on Mar 9, 2023 14:25:06 GMT
With Fresenius having multiple different machines, each requiring boards specific to that machine, are you sure you have the right board for the right machine?
|
|
|
Post by Taco123 on Mar 9, 2023 17:43:16 GMT
Its a 2008T machine with 26k hours on it. I'm sure I got the right part.
|
|
max
New Member
Posts: 9
|
Post by max on Mar 9, 2023 22:54:48 GMT
If the EPROM chip was replaced with the new Functional board calibrate all calibrations.
|
|